- Certification: ISO9001, ISO14001,CE
- Use: Steel Wire Shot Blasting
- Port: Qingdao Seaport
Steel Wire Shot Blasting Machine
The steel Wire Shot Blasting Machine are designed for blast processing carbon steel wire, the specification as follows:
- Processing steel wire diameter: Φ6mm to Φ32mm
- Blast processing speed: 0 to 80m/min(it is determined by the winder unit)
- Using abrasive type: Φ0.3mm to Φ0.5mm casting steel shot which hardness is HRC45 to HRC50
- Steel wire surface roughness after shot blasting: Ra12.5μm
- Surface finish: 100%
Technical Support1．Blast wheel layout adopt 3-D dynamic simulation design, ensures optimal shot blasting angle and distance, treat the object items on all sides with a high quality surface appearance but without overlapped and dead zone.
2．The equipment designed was fitted with our heavy-duty blast wheel system, which generates significant operating cost reductions due to faster through put times, as well as reductions in shot-blasting media consumption and energy requirements.
3．The blast wheel of the machine are equipped with shielding facility to lower the noise level.
4．The equipment adopt pneumatic control abrasive dosing system, which eliminate the blast wheel idling and injuring workers
5．The equipment is equipped with adequate safety interlock device, which meet European safety standard.
6．The machine adopt environment friendly high efficiency cartridge filter, dust collecting efficiency reach to 99.9%
7．All the abrasive recycle system automatic fault detection
8．The equipment adopt labyrinth sealing mechanism at the enter and exit gate.
9．The blasting cabinet of roller conveyor shot blasting machine adopt 8mm steel plate welding together, which have high strength and will not generate vibration during working. The guard plate of the blasting cabinet adopt 12mm high manganese steel plate which prolong the blasting chamber lifespan.
10．Pneumatic swing-rotating sealing mechanism for H beam effectively prevent the abrasive spilling out.
Blast cabinet• Welded by steel plates and profile steel, have enough strength and rigidity.
• ZGMn13 steel guard plate, which is hard enough to deal with the shot blasting from 35HRC to more than 55HRC.
• High impact toughness can make full use of the reflection kinetic energy of shot to continue to blast cleaning the surface of work piece, so greatly enhance the cleaning efficiency and quality.
• High chrome wear resistant cast iron grate guard plate which protect the screw conveyor and prevent big clump to get into the hopper damaging the bottom screw conveyor
Blast turbines• Cantilever centrifugal high efficiency blast wheel, can operate clockwise or counter-clockwise, optimum abrasive flow rate for faster cleaning.
• impeller adopted #40 Chrome wear resistant cast iron.
• High chrome wear resistant cast iron for blades, control cage, abrasive distributor.
• Dynamic and static balance.
• Blades of impeller weight tolerance≤±1.5g.
• Unbalanced torque tolerance≤±7.5Nmm.
• Direct drive blast wheel with special motor bearings means less spare parts, less noise, energy-efficient, large abrasive flow rate and good cleaning effect ,etc. advantages.
• Machined housing ensures proper alignment of all internal parts.
• Less part wear due to greater concentricity and more precise alignment.
• Safety interlock is fitted on the housing cover to protect the workers safety.
• Particular guard liner structure increase the abrasion resistant lifespan 60% to 200%.
Coil wire shot blasting machine, steel coil shot blasting machine, coil wire rod shot blasting machine
If you have any suggestions or opinions about our products,please leave a message,and we will immediately answer your questions. Thanks for your support.